Essence We.R Guia do Utilizador descarregar pdf (Página 111)

Installation of the WeR@Home™ System

System User Guide

111

The mounting base, of both parts, is the Magnetic Sensor back cover (in the Transmitter unit it also serves the

purpose of battery cover).

For the Transmitter unit, the base should be disassembled from the Transmitter body, as demonstrated in

Figure 80 above, and attached to the wall either by the double-sided tape (pre-attached to the base) or using

screws as demonstrated in Figure 83 below.

3.8.2.1 Magnetic Sensor Positioning Recommendations

For optimal surveillance, the following factors must be taken into consideration when selecting the Magnetic

Sensor mounting position:

n A flat vertical window or door surface.

n Attach the Magnetic Sensor (applicable for both parts) to a surface that is clean, dry, flat and smooth.

n The Magnetic Sensor must be mounted within 700m (2300ft) (open air nominal) of the CCU.

n Typically, the Transmitter unit will be attached onto the fixed frame of the window/door while the

Magnet unit – to the moving edge.

Figure 81: Typical Location for Magnetic Sensor Installation

n Special attention should be given, throughout the installation process of the Magnetic Sensor, to the

final arrangement of the two units – they should end up aligned to each other (dot-to-dot) as

demonstrated in Figure 82 below, as well as mounted with 1-2mm (0.04-0.08 in.) gap between them

when door/window is closed.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 290 291

Sem comentários

Essence We.R Guia do Utilizador Página 111